Wake-Up on RTC Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the operating system, before this function will work.
IRQs Activities
Please refer to section
3-8-1.1 IRQs Activities
CMOS Setup Utility – Copyright(C)
IRQs Activities
|
|
|
|
| |
Primary INTR | ON |
| Item Help | ||
IRQ3 | (COM 2) | Enabled | |||
| |||||
IRQ4 | (COM 1) | Enabled |
| ||
IRQ5 | (LPT 2) | Enabled | Menu Level >>> | ||
IRQ6 | (Floppy Disk) | Enabled |
| ||
IRQ7 | (LPT 1) | Enabled |
| ||
IRQ8 | (RTC Alarm) | Disabled |
| ||
IRQ9 | (IRQ2 Redir) | Disabled |
| ||
IRQ10 | (Reserved) | Disabled |
| ||
IRQ11 | (Reserved) | Disabled |
| ||
IRQ12 | (PS/2 Mouse) | Enabled |
| ||
IRQ13 | (Coprocessor) | Disabled |
| ||
IRQ14 | (Hard Disk) | Enabled |
| ||
IRQ15 | (Reserved) | Disabled |
| ||
↑↓→← Move Enter:Select
F5:Previous Values | F6:Optimized Defaults F7:Standard Defaults |
3-9 PnP/ PCI Configuration Setup
This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when communicating with its own special components. This section covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings.
35
