Intel manual Novell NetWare* v .0 does not install on SDS2, Revision Order Number A85874-002

Errata Listing	Intel® Server Board SDS2
Implication:	The SDS2 server board will not complete POST if more than 4GB or more of
	total system memory is installed and the Extended RAM step option in BIOS
	Setup is set to “Every Location”.
Workaround:	Choose a different option besides “Every Location” for the Advanced à Memory
	Configuration à Extended RAM Step BIOS Setup option. The default setting for
	this option is “Disabled”.
Status:	Fixed. This issue is fixed in SDS2 BIOS Production Release 2.4 (Build 47) and
	later versions.

13.Novell NetWare* v. 6.0 does not install on SDS2

Problem:	Novell NetWare* v. 6.0 will not install on the SDS2 server board. The install
	proceeds normally until the NetWare v. 6.0 splash screen appears for the first
	time. The install will then start iterating the portion of the install from “initializing
	system resources” to the splash screen indefinitely.
Implication:	Novell NetWare* v. 6.0 cannot be installed to the SDS2 server board.
Workaround:	None.
Status:	Fixed. This issue has been root caused as a Novell NetWare* v. 6.0 operating
	system issue. Novell has released NetWare v. 6.0 support pack (SP) 1, which
	fixes this issue. Intel has verified the Novell NetWare* v. 6.0 can be
	successfully installed to the SDS2 server board when SP1 is applied. The
	procedure for applying SP1 is as follows:

1.Create a 200MB bootable DOS partition on the installation hard drive.

2.Format the partition and create a directory called “nwupdate”.

3.Copy server.exe from the SP1 directory “startup” into the “nwupdate” directory.

4.Launch the Novell NetWare* v. 6.0 install, and select to use the existing boot partition.

14.Adaptec* 2100S RAID controller causes system lockup and video blanking

Problem:	When an Adaptec* 2100S RAID controller is installed in the SDS2 server board,
	the video will blank and the system will lock up during POST when the onboard
	SCSI controller option ROM is set to “Enabled” in the SDS2 BIOS setup (defalt
	option).
Implication:	The Adaptec* 2100S RAID controller cannot be used with the SDS2 server
	board when the onboard SCSI controller option ROM is set to “Enabled” in the
	SDS2 BIOS setup.

114	Revision 1.2
Order Number:	A85874-002