Intel SDS2 manual Boot to service partition via modem fails, Revision Order Number A85874-002

Errata Listing Intel® Server Board SDS2

22.Data miscompares when using Seagate* ATA III model ST310215A hard drives

Problem:	Intel has induced data miscompares in SDS2 sytems configured with a
	Seagate* ATA III model ST310215A hard drive under extreme workloads during
	validation testing. Intel has verfied that other hard drive models are not affected
	by this issue.
Implication:	The Seagate* ATA III model ST310215A hard drive installed on the Intel® Server
	Board SDS2 is currently not a supported configuration and should not be
	implemented in a production environment.
Workaround:	None.
Status:	Fix. Intel has identified a fix for this issue, which will be incorporated in the
	SDS2 FAB 5 server board.

23.Boot to service partition via modem fails

Problem:	When utilizing the direct platform control (DPC) feature of Intel Server Control
	(ISC) v. 3.5.2 software to boot a SDS2 server board to the service partition via
	modem, the server board will hang during ROM-DOS load.
Implication:	The DPC feature of ISC v. 3.5.2 software cannot be used to remotely boot the
	SDS2 server board to the service partion via modem.
Workaround:	None.
Status:	Fixed. SDS2 BIOS Production Release 2.6, Build 49 and later versions include
	a fix for this issue.

24.Secondary IDE References Added To Documentation for FAB 5

Problem:	New FAB5 AXXXX-502 has second IDE (ATA 100) connector enabled.
Implication:	Users now have second IDE channel for use in system configurations
Workaround:	None
Status:	Fixed with the release of FAB5 SDS2 severboard in October 2002.

25.Potential Mylex AcceleRAID 352 Adaptor Card Mechanical Interference at PCI Slot 6.

120	Revision 1.2
Order Number:	A85874-002