Intel SDS2 manual Revision Order Number A85874-002

Errata Listing	Intel® Server Board SDS2
Implication:	If you are installing the Intel Server Board SDS2 into the Intel SC5100 Server
	Chassis, Intel recommends installing the rubber bumper included with the
	server board. If you are installing the Intel Server Board SDS2 into a chassis
	other than the Intel SC5100 Server Chassis, compare the rubber bumper height
	to the chassi standoff height. If the bumper is the same height as the standoffs
	in the chasis, install the rubber bumper included with the SDS2 Server Board. If
	the suport is not the same height, procure a bumper that matches the height of
	the standoffs used in your chassis. The rubber bumper should be installed on
	the chassis as follows:
	For the Intel SC5100 chassis:
	1.Remove the backing from one of the rubber bumpers included with your
	chassis.
	2.Press the rubber bumper firmly into place approximately ½ inch (2 cm) to the
	right of the chassis baseboard hole marked “9.” See location A below.
	For other chassis:
	1.Remove the backing from one of the rubber bumpers included with your
	chassis.
	2.Locate the chassis standoff labeled “1” in your chassis.
	3.Place the rubber bumper at a location 6.25 inches (16 cm) toward the front of
	the chassis and 7.75 inches (19 cm) toward the center of the chassis from
	standoff 1. See location B below.
	4.Press the rubber firmly into place.

118	Revision 1.2
Order Number:	A85874-002