Parameter | Description |
Disable WPS | Check to disable |
WPS Status | When the settings are factory defaults (out of the box), it |
| is set to an open security and unconfigured state. “WPS |
| Status” will display it as “UnConfigured.” If it already |
| shows “Configured,” some registrars such as Vista WCN |
| will not configure the router, and you’ll need to go to the |
| Backup/Restore screen and click “Reset” to reload the |
| factory default settings. |
| want to change the PIN, click “Regenerate PIN” and |
| “Apply Changes.” To create your own PIN, enter a four- |
| digit PIN without checksum and click “Apply Changes.” |
| However, this would not be recommended, since the |
| registrar side needs to be supported with a |
Regenerate PIN | Click to regenerate the |
Push Button | Clicking this button will invoke the PBC method of WPS. |
Configuration | It is only used when the router acts as a registrar. |
Start PBC | Click to start the Push Button method of WPS. |
Reset | Click to restore the original values. |
Client PIN Number | This is only used when users want their station to join the |
| router’s network. The length of the PIN is limited to four |
57
