ParameterDescription
IP QoS | Click the radio button to enable or disable the function. |
Default QoS | Select the default mode of QoS from the menu. |
| • IP Precedence: In QoS, a |
| of the IP header (see RFC 791). Using IP Precedence, |
| a network administrator can assign values from 0 (the |
| default) to 7 to classify and prioritize types of traffic. |
| • 802.1P: IEEE 802.1p is a |
| Ethernet frame header when using tagged frames on an |
| 802.1 network. It specifies a priority value between 0 |
| and 7 inclusive that can be used by Quality of Service |
| (QoS) disciplines to differentiate traffic. |
Source IP | The IP address of the traffic source. |
Source Netmask | The source IP netmask. This field is required if the |
| source IP has been entered. |
Source Port | The source port of the selected protocol. You cannot |
| configure this field without entering the protocol first. |
Destination IP | The IP address of the traffic destination. |
Destination Netmask | The destination IP netmask. This field is required if the |
| destination IP has been entered. |
Destination Port | The destination port of the selected protocol. You cannot |
| configure this field without entering the protocol first. |
Protocol | The selections are TCP, UDP, ICMP and blank for none. |
| This field is required if the source port or destination port |
| has been entered. |
Physical Port | The incoming ports. The selections include LAN ports, |
| wireless port and blank for not applicable. |
Outbound Priority | The priority level for the traffic that matches this |
| classification rule. The possible selections are (in the |
| descending priority): p0, p1, p2, p3. |
802.1p | Select this field to mark the |
| the 802.1p header of the packet that matches this |
| classification rule. Note that this 802.1p marking is |
| workable on a given PVC channel only if the VLAN tag is |
| enabled in this PVC channel. |
59
