Network Video Server User’s Guide
RI : Ring Indicator
Pan/Tilt/Zoom Control
Pan/Tilt/Zoom control interface of NETWORK VIDEO SERVER is initially set to support RS485. To operate Pan/Tilt/Zoom control through NETWORK VIDEO SERVER, camera or receiver is to be connected to 9PIN DIN connector of rear panel as shown below;
9PIN DIN Connector | Receiver or Camera |
7 | + |
8 | - |
If your camera supports RS232 instead RS485 for Pan/Tilt/Zoom control, then, follow the next directions.
1.Uncover the rear panel.
2.Find “J3” on the PCB board.
3.Change jumper setting as shown below.
J3
1 2
4. Then, cover the rear panel and connect your camera or receiver as shown below.
9PIN DIN Connector | Receiver or Camera |
4 | RX |
5 | GND |
6 | TX |
63
