APPENDIX B | PEN*KEYR Utilities Program |
“119” Invalid name number “120” No answer
“121” Name not found
“122” Name in use on remote adapter “123” Name deleted
“124” Session ended abnormally “125” Name conflict
“126” Incompatible remote device “133” Network interface is busy “134” Too many commands outstanding “135” Invalid LAN adapter number
“136” Command completed while cancel occurring “138” Command not valid to cancel
These error codes apply when COMM SETTINGS is set to
MODEM/DIRECT and PROTOCOL is set to TTY:
“0” | No error |
|
“6” | [ESC] key pressed, aborting communications | |
“11” | Invalid parameter specified in control file | |
“23” | End of transmission | |
“101” | Line lost |
|
“102” | Parity error |
|
“103” | Character gap too long | |
“104” | Data loss |
|
“105” | Excessive NAKs (negative acknowledgements) | |
“106” | Block count error | |
“107” | Block check error | |
“108” | Block framing error | |
“109” | Control character error | |
“2xx” | Modem error |
|
“xx” Hayes response code, or code defined by | ||
| program: | |
| “03” | No carrier |
| “04” | Command not recognized |
| “06” | No dial tone |
| “07” | Dialed number is busy |
