Main Memory | Intermec 6110 specification

General Information

SECTION 1

pacity when two of the contacts are touched at the same time. More on this in Section 2 on page 2-9. A second meth- od is to use a software fuel gauge based on the APM 1.1 specification.

If your hand-held computer goes into a shutdown mode be- cause of low battery condition, data is protected by the backup battery. Your computer contains two 100 mA hour vanadium lithium backup batteries. The backup battery charges itself from the main pack or a charging source so it is constantly ready to take over data protection.

This user’s guide will occasionally use the term “cycles” when presenting rechargeable battery instructions. Cycles, are the number of times the rechargeable battery pack can be charged and discharged during the life of battery. The Lithium Ion rechargeable battery design, used in the main pack, should give you approximately 500 cycles of use. There are no guarantees on this number because it depends greatly on how the battery pack is used and cared for.

Memory

Three types of memory are available with this computer:

"Main Memory DRAM

"Flash ROM

"PC Cards

Main Memory

Standard main memory DRAM configuration is 8 mega- bytes (MB), this can be extended to 16, or 32 MBs. Main memory was ordered at the time your unit was purchased. You are able to upgrade to a larger memory size by having a new memory board installed at your Customer Support Center.

The main memory is protected by the backup battery dur- ing low main battery conditions or when the main battery pack is removed.

1-66110 Hand-Held Computer User’s Guide

Image 12

Intermec 6110 manual Main Memory

Contents

USER’S Guide Acknowledgments Contents Operation Figures Tables Section About This User’s GuideSection Hand-Held Computer Description Appendix aAppendix B Front View Back View Hand-Held Computer Keyboard Battery DisplayBacklight Memory Main Memory Flash ROM PC Cards PC Card Slots PC Card Slots Gold Shift Key Suspend and Resume Key Options and Accessories ResettingSerial Ports Radio Card Integrated Scanner Pod Port Replicator Slide the Port Replicator onto the computer as shown Magnetic Stripe Reader Serial Pod GSM with SIM card Hand-Held Computer Specifications Power source System Components Introduction Getting Started Rechargeable Battery Label Replace the battery with a similar kind Installing the Main Battery Charging The Batteries Your Hand-Held Computer Power Status LED External Source Multipack Charger Single Pack Charger Removing the Main Battery Measuring Battery Pack Capacity Backup Battery Backup Battery Life Using PC Cards to Load Your Programs Installing PC CardsBooting Bios Update Accessing the PC Card Slots Removing PC Cards Installing a Modem Card Installing Modem Cable Using the Magnetic Stripe Reader MSR Installing the Subscriber Identity Module SIM Remove the SIM cover from the hand-held computer Installing SIM Routine Care and Maintenance Low Battery Indication Cleaning Your Hand-Held Computer Docking ConnectorsCase and Display Troubleshooting Troubleshooting Chart Are lighting Condition Solution Hand-Held Not Power Up Computer Does Repair Service Connector Pin-Outs Appendix a Pin Docking Connector Pin Signal Function RJ-45 Phone Jack Pin-Outs Phone Jack Pin-Outs Appendix a Appendix B Entry PointPop-Up Menus Drop-Down Lists Alphanumeric Fields Network Parameters Title Screen Language Selection Communications Menu Communications Menu appears after the Title Screen Option 1 Begin Comm Session Begin Comm Session with Network Hand-Held Computer User’s Guide B-9 Begin Comm Session with MODEM/DIRECT Begin Comm Session with Accessory Card Begin Comm Session with Interserver Session Status ESC Hand-Held Computer User’s Guide B-13 Novell Netware 800 ESC key Appendix B Option 2 Comm Setting Suboption 1 Network Suboption 2 MODEM/DIRECT Suboption 3 Accessory Card Suboption 6 Interserver Suboption 4 Handheld Suboption 5 Remote OPS Option 3 Unit ID Option 4 Network Parameters Network Parameters with Nrinet or Tftp Option 4 Modem Parameters Network Parameters with Novell NetwareSuboption 1 Modem Type Modem Init String Momentarily, the computer displays the modem’s response Suboption 2 Protocol Suboption 3 BPS Rate Option 5 Network Interface Suboption 4 Data FormatSuboption 5 Auto Answer Option 5 Phone Number Option 9 Advanced Utilities Suboption 1 SET DATE/TIME API Async Boot Default Drive Bootable ATABisync BInary SYNChronous communications Button Click Cmos Complementary Metal Oxide SemiconductorController CPU Default Drive DockDOS Disk Operating System Double-Click Eeprom EOT ETX End Of Text FlashFlash Card FSK Frequency Shift Keying GUI/PM Host Address Host ComputerHost Controller Host Port com4980 Internet IrDALAN Local Area Network Layer LCD Native Mode ADK MQL Multi-Quad LockboxMS-DOS Microsoft Disk Operating System NAK Negative Acknowledgement Nmsd NrinetNull Open Wireless LAN Node Open SystemsPan Border PC Personal Computer PEN*KEY PenRight Physical Port PixelPlug and Play Polled Protocol Portrait Mode Port ReplicatorProgrammer’s Reference Guide Proprietary Systems RAS RXD TTY TXD Wireless UCC Uniform Code CouncilUCS Uniform Communications Standard UPC Universal Product Code Index Index