Invacare Pronto M61 manual Depth, Adjusting the Footboard Assembly Angle

SECTION 8—FOOTBOARD ASSEMBLY

Bottom View of	Set Screw, Washer
Footboard		and Jam Nut

Footboard

Assembly

FIGURE 8.2 Adjusting the Footboard Assembly - Angle

Depth

NOTE: For this procedure, refer to FIGURE 8.3.

1.Remove the quick release pin that secures the footboard assembly to the wheelchair frame.

WARNING

Make sure the detent balls of the quick-release pin are fully released and beyond the outer edge of the tube before operating the wheelchair. Otherwise, injury and/or damage may result.

Keep detent balls clean.

2.Adjust footboard to one of three mounting positions.

3.Install the quick release pin. Make sure the detent balls of the quick‐release pin are fully released and beyond the outer edge of the tube (Detail “A”).

Top Shroud

Three Depth

Adjustment Holes

Footboard

Assembly

Mounting

DETAIL “A” - BOTTOM VIEW OF

FOOTBOARD

Quick Release Pin

Hole

Quick	Detent
Release Pin	Ball

Outer Edge

of Tube

Detent Balls

FIGURE 8.3 Adjusting the Footboard Assembly - Depth

Part No 1125085 47 Pronto® M51™and M61™with SureStep®