SECTION 13—ACCESSORIES

Installing/Removing/Using the Walker Holder

INSTALLATION WARNINGS

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.

The installation of the walker holder onto the back of the wheelchair seat increases the length of the wheelchair up to nine inches. When turning the wheelchair it is important to take note of this increased length - otherwise, injury and/or damage to surrounding property may result.

NOTE: For this procedure, refer to FIGURE 13.3.

Installing/Removing the Walker Holder

NOTE: Reverse this procedure to remove the walker holder.

1.If necessary, loosen but do not remove the mounting knob.

2.Install the walker holder into the accessory tube.

3.Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.

Using the Walker Holder

1.Fold walker. Refer to instructions provided with the walker. NOTE: Walker MUST be folded before using walker holder.

2.Hang folded walker on walker holder hooks.

3.Secure walker with hook and loop straps.

Seat

Walker Holder

Accessory

Tube

DETAIL “A”

Hook

Hook and

Loop Straps

Mounting Knob

FIGURE 13.3 Installing/Removing/Using the Walker Holder

Pronto® M51™and M61™with SureStep®

78

Part No 1125085

Page 78
Image 78
Invacare Pronto M61 manual Installing/Removing/Using the Walker Holder, Installing/Removing the Walker Holder