SECTION 9—FRONT RIGGINGS

Model PH904A and PHAL4A

NOTE: For this procedure, refer to FIGURE 9.3.

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

1.Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary.

Footrest

Support

Lug Bolt

Locknut

 

Lower

Footrest

FIGURE 9.3 Adjusting Footrest Height -

Model PH904A and PHAL4A

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 9.4.

1.Note the position of hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1‐6 to reassemble.

Locknut

Coved

Washer

 

Coved

Hex Bolt

Washer

 

Footrest

Phillips

Bolt

Support

Spacer

 

Lower

Heel Loop

Footrest

 

 

Locknut

FIGURE 9.4 Replacing Heel Loops

NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure.

Pronto® M51™and M61™with SureStep®

50

Part No 1125085

Page 50
Image 50
Invacare Pronto M61 manual Replacing Heel Loops, Model PH904A and PHAL4A