SECTION 10—TOP SHROUD AND WHEELS

SECTION 10—TOP SHROUD AND WHEELS

WARNING

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

Replacing the Flat Free Tires on the Wheel Rim

WARNING

DO NOT attempt to replace flat free tires. This procedure MUST be performed by a qualified technician.

NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat spots will vanish with continued use of the wheelchair.

Removing/Installing the Top Shroud

NOTE: For this procedure, refer to FIGURE 10.1 on page 57.

Removing

1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.

2.M61 Wheelchairs Only ‐ Remove the joystick cable from the clip on the top shroud.

3.Remove the seat. Refer to Removing/Installing the Seat Assembly on page 42.

4.Remove the top shroud by pulling it up off the base frame.

Installing

1.Pull joystick cable through the center hole in the top shroud.

2.Place the top shroud on the base frame and push downward to engage the hook and loop straps.

3.M61 Wheelchairs Only ‐ Secure the joystick cable using the clip on the top shroud.

4.Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 42.

5.Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.

Pronto® M51™and M61™with SureStep®

56

Part No 1125085

Page 56
Image 56
Invacare Pronto M61 manual TOP Shroud and Wheels, Replacing the Flat Free Tires on the Wheel Rim