SECTION 9—FRONT RIGGINGS
Removing
1.Push the front rigging release lever inward and rotate the footrest out.
2.Lift up on front rigging and remove from the wheelchair.
3.Repeat STEPS 1‐2 for opposite side of wheelchair.
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 9.2.
1.Remove any accessories from the footrest(s).
2.Remove the footrest from the wheelchair. Refer to Installing/Removing Front Riggings on page 48.
NOTE: Lay footrest on a flat surface to simplify section.
3.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.
4.Reposition the lower footrest to the desired height.
5.Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest support. Tighten securely.
6.Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary.
7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 48.
8.Reinstall any accessories onto the footrest(s).
Locknut | Footrest Support |
| |
| Coved Washer |
| Hex Bolt |
Coved Washer |
|
Lower Footrest
FIGURE 9.2 Adjusting Footrest Height - Model PHWH93
Part No 1125085 | 49 | Pronto® M51™and M61™with SureStep® |
