SECTION 10—TOP SHROUD AND WHEELS

Right Motor

Release Lever

Shown

Disengaged

Engaged

FIGURE 10.2 Engaging/Disengaging Motor Release Lever

Replacing Front/Rear Caster Assemblies

NOTE: For this procedure, refer to FIGURE 10.3.

NOTE: Front and rear caster assemblies are replaced in the same manner.

NOTE: When replacing the front/rear caster assemblies, it is necessary to brace the caster assemblies to prevent the wheel from spinning.

1.Remove the mounting screw, two washers, and locknut that secures the caster to the fork.

2.Remove the caster and discard.

3.Secure new caster to fork with existing mounting screw, two washers and locknut (FIGURE 10.3). Securely tighten.

Locknut

Mounting

Screw

Washer

Washer

 

Caster

FIGURE 10.3 Replacing Front/Rear Caster Assemblies

Pronto® M51™and M61™with SureStep®

58

Part No 1125085

Page 58
Image 58
Invacare Pronto M61 manual Replacing Front/Rear Caster Assemblies, Engaging/Disengaging Motor Release Lever