SECTION 13—ACCESSORIES

SECTION 13—ACCESSORIES

WARNING

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

Installing/Removing the Crutch/Cane Holder

WARNING

The installation of the crutch/cane holder onto the back of the seat significantly increases the length of the wheelchair. When turning the wheelchair or swiveling the wheelchair seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.

NOTE: For this procedure, refer to FIGURE 13.1.

NOTE: The Crutch/Cane Holder and Oxygen Holder all install into the accessory tube. Only one of these may be installed at a time.

NOTE: To remove, reverse the following procedure.

Installing

1.If necessary, loosen but do not remove the mounting knob.

2.Install the crutch/cane holder into the accessory tube located on the back of the seat.

3.Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.

4.Align slot on base with hook on crutch/cane holder and slide base down into position.

Seat

Crutch/Cane

 

Holder

Accessory

 

 

Tube

Hook

 

 

Mounting

Base

Knob

FIGURE 13.1 Installing/Removing the Crutch/Cane Holder

Pronto® M51™and M61™with SureStep®

76

Part No 1125085

Page 76
Image 76
Invacare Pronto M61 manual Accessories, Installing/Removing the Crutch/Cane Holder