SECTION 9—FRONT RIGGINGS
Inner Mounting Holes | Mounting Bolts |
|
Seat Frame
Telescoping Front
Spacer | Rigging Support |
|
| 8 |
|
| Hinge |
Locknuts | 7 |
|
| Pins |
|
|
|
| |
Mounting Holes | 6 | 5 | 3 |
|
| 4 | 2 | ||
|
| |||
|
|
|
| |
|
|
| Not Used | |
FRONT RIGGING | STANDARD | 1 INCH OUT | 2 INCHES OUT | ||||
MODEL | POSITION |
|
|
|
| ||
|
|
|
|
|
|
| |
| 18 inches | 20 inches | 18 inches | 20 inches | 18 inches | 20 inches | |
| wide | wide | wide | wide | wide | wide | |
|
|
|
|
|
|
| |
PHW93 | Holes | Holes | Holes | Holes | Holes | Holes | |
4 and 5 | 4 and 5 | 5 and 6 | 5 and 6 | 6 and 7 | 6 and 7 | ||
| |||||||
|
|
|
|
|
|
| |
PH904A and PHAL4A | Holes | Holes | Holes | Holes | Holes | Holes | |
3 and 4 | 3 and 4 | 4 and 5 | 4 and 5 | 5 and 6 | 5 and 6 | ||
| |||||||
|
|
|
|
|
|
| |
FIGURE 9.7 Adjusting/Replacing Telescoping Front Rigging Supports - Standard Seat
ASBA Seat
NOTE: For this procedure, refer to FIGURE 9.8 on page 55.
1.Remove the two mounting screws, spacers and locknuts that secure the telescoping front rigging support to the seat frame.
2.Perform one of the following:
•Slide existing telescoping front rigging support to one of three depth positions.
•Remove existing telescoping front rigging.
3.Secure telescoping front rigging at desired depth with existing two mounting screws, spacers, and locknuts. Securely tighten.
Pronto® M51™and M61™with SureStep® | 54 | Part No 1125085 |
