Specifications | Ricoh RDC-5300 guide

Specifications

■ General
● Video Signal Protocol	: PAL/NTSC

●Power Source and Voltage : Batteries: 6 volts AC: 5 volts

●Dimensions (W ⋅ H ⋅ D) : 131.1 ⋅ 68.8 ⋅ 54.0 mm (5.17” ⋅ 2.71” ⋅ 2.13”) (excluding grips)

● Weight

: Approximately 350 g (12 oz.) (excluding batteries)

●Operating Range -

Temperature

: 0° to 40° C (32° to 104 F)

●Operating Range - Relative

Humidity	: 85% or less
● Storage	: –20° to 60°C (–4° to 140°F)
■ Camera
● CCD	: 2,310,000 million square pixels (effective: 2,160,000
	million)
● Lens	: Zoom lens F=3.2 - 3.7
• Focal length	: f=8 - 24 mm (equivalent to 38-114 mm on 35mm
	camera format)
• Minimum shooting range	: Approximately 4.0 cm (1.6”) (macro)
● Viewfinder
• Type	: Real image
• Magnification	: Telescope 0.35X, standard 0.57X, wide angle 1.00X
• Parallax correction	: No
• Diopter	: –1 dpt
● Monitor
• Display Size	: 1.8”
• Drive System	: TFT Active Matrix System
• Picture Elements	: Approximately 110,000 pixels
● White Balance	: Auto/Preset (Daylight, Cloudy (Overcast),
	Fluorescent Light, Tungsten Light)
● Exposure Compensation
• Light Metering System	: Centerweighted
• Exposure Value Memory
System	: Auto backlighting detection
	Manual compensation, ±2.0 EV (in 0.5 EV
	increments)
• Metering	: TTL-CCD method
• Flash Automatic Exposure	: Yes (daylight synchro)
• Shutter Speed	: 1-1/500
• Minimum diaphragm setting : F 15.0 – F 17.2
• ISO Sensitivity	: Approximately equivalent to 100
● Distance Adjustment
• Autofocus Method	: TTL-CCD AF
• Autofocus Range	: Approximately 4.0 cm (1.6”) to infinity

5

Miscellaneous

127

Image 129

Ricoh RDC-5300 manual Specifications

Contents

Page Copyright Introduction Camera Features Table of Contents Advanced Shooting Miscellaneous Changing Camera Settings Sample Warnings Safety Precautions Turn off the power immediately if any metallic object Keep the batteries used in this equipment out Do not use the equipment near flammable gases Safety Warnings for Accessories Camera Body Parts & Names AC Adapter optional Bottom Play Mode Displays Recording Mode DisplaysExplanation of LCD Monitor Displays LCD Monitor No Card Status Explanation and Remedy Reference Initial display Setup mode Error MessagesError Explanation and Remedy Reference LCD Panel Displays Appearing during Recording Displays Appearing during Communication Communication ModeDisplays Appearing during Playback/Erasure On an RS-232C cable connection Error Displays and Contents Menus SET UP Menu White Balance Record Menu Play Menu Erase MenuTo a PC Preparations Basic Operation/Quick ReferenceLoading the Batteries p.27-29 Inserting a SmartMedia Memory Card p.32-33 Basic Shooting Procedure p.40-51 Setting the Date and Time p.35-37Shooting Press the shutter release button to record the image Using the Self-Timer p.61-62 Changing the Flash Mode p.54-56Set the mode dial to Press the self timer button Playback Erasing Files p.94-97 ErasingPress the shutter release button You want to erase and press the Enter buttonPage Getting Started Before Using the Camera Checking the Package ContentsAttaching the Wrist Strap Loading the AA Batteries Powering the CameraRechargeable Batteries Getting Started Economizing on Batteries Close the battery coverLoad the batteries Shooting and Playback Guidelines Handling Precautions Using an AC AdapterUsing the AC Adapter Battery type Approximate Recording Time Playback Time See Turning on the Camera p.41 What is a SmartMedia Memory Card? SmartMedia Memory CardsProtecting Against Accidental Writing Inserting a SmartMedia Memory Card Inserting CardData Formatting a SmartMedia Memory Card Removing CardClose the card door Press the shutter release button Set the mode dial to Setting the Date and Time Before You Start RecordingPress the or button to select Date Press the Enter button Press the Display button to select the date display methodPress the and buttons to change the blinking numeral Press the Enter button to flash the digit you want changed How To Hold the Camera Adjusting the LCD Monitor BrightnessTips How to Verify the Date and Time When viewing through the viewfinder Press the shutter release button lightly with your fingertip When viewing using the LCD monitor Basic Shooting Operation Flow Basic Shooting Slide the center button of power switch to on Using the Display button to turn the power on and offTurning on the Camera Basic Shooting Auto Power-Off Switching ModesSelecting a Recording Destination Press the CARD/IN button and select a Recording destination Switching PIC Image quality Modes Selecting PIC Image quality ModeSelecting a PIC Image quality Mode Press the PIC button and select a PIC Image quality mode Selecting Recording Mode Switching Recording ModesApproximate File Sizes by PIC Image quality Mode Set the mode dial to and press Menu button Selecting a Recording Mode for the PIC modePress the Enter button to choose Recording mode Press the or button to select Zooming In Telephoto Setting Setting the Size of the Subject ZoomZooming Out Wide Angle Setting Digital Zoom Function How to View Images on the LCD Monitor Viewing Through the ViewfinderViewing Through the LCD Monitor When the flash lamp lights Shooting Still Picture ModeAim the camera at your subject Press the or button to set the size of the subject Still frame mode /text mode Tips Using the Camera for Extended Periods of Time When Focusing is Difficult Tips LCD Monitor Display Function Page Advanced Shooting Chapter Changing Flash Modes Flash ModesEffective Range of the Flash How to Cancel a mode Changing the flash modePress the release button to take the photograph AdvancedPage Setting the Exposure Compensation Setting the Exposure CompensationSet the mode dial to Press Menu button How To Cancel the Exposure Compensation Setting Press the or button to change the compensation levelPress the shutter release button to shoot Subject Changing the White Balance Mode Changing the White Balance ModeSwitching White Balance Modes Subjects Difficult to Correct in Auto Mode How to cancel the mode Press the and buttons to select White balance mode Using the Self-Timer Set the mode dial to and press the self timer buttonSpecial Shooting Functions How to Use the Focus Lock When to Use the Focus LockTips Remote Control Focus Lock Shooting Mode Shooting p.63 Focus Mode ShootingPress the shutter release button lightly Hold it Shutter release button down fully Set the Mode dial to and then press the Menu button How To Cancel Focus ModesPress the up or down button to select Focus Set the mode dial to and press the Menu button Date Imprint ModeHow To Cancel Date Imprinting Mode Press the shutter release button to shoot the subject Menu button Redeye Reduction Mode How To Cancel Red-eye Reduction Mode Monochrome Mode Black & White SepiaHow To Cancel Monotone Mode Press the or button to select Monochrome Second Interval Time lapse Shooting Mode Press the Menu button Press the release buttonShutter release. The set time interval will not change How To Cancel Interval Shooting Using Soft ModeHow To Cancel Shooting How To Cancel Soft Mode Mode Shutter Speed Press the or button to select S ModePress the shutter release button to take the picture How To Cancel the S Mode Using Auto BracketHow To Cancel Auto Bracket Press the up or down button to turn Auto Bracket to on AdvancedShooting Macro Shooting Close-up Shooting Shutter Release Button Focal Range for Macro Shooting PLAYBACK/ERASING Playback Display Before Starting to Playback Recorded Images Using the Camera for Extended Periods of Time Connecting to a TVCheck that both the camera and the TV are turned off Playback/Erasing Playing Back a File Switch Display ModesFiles That Can Be Played on the Camera Select a source file to playback Playback Display Playing an Image File Multi Image Playback Set the mode dial to Press the Display button Press the or button to verify the image file Zoom Playback Auto Playback How To Cancel Auto Playback Protecting a File Press the Menu button to cancel the protect setting Copying Files How To Cancel the SettingCopying all images Press the CARD/IN button and select the copy source Copying Selected Image Mount a SmartMedia memory card in the camera Playing a File Shot with Another Brand of Camera Setting a Print Service Setting Dpof Direct Print of File Specifying the number of prints When previous Dpof settings exist Specifying the number of indexes How to cancel the settings Canceling Dpof settings Setting Secret File Setting a passwordSet the Mode dial to Setup Setting secret files When you forget your passwordHow to Cancel a password How To Cancel settings How to Display Secret FileWhen Secret File is already set Select the Erase Mode Switch To the Erase ModeErasing a File Image Select a source file to erase Erase Press the or button to select anImage file to erase Erase All Images Erase Selected Files Images Page 107 Miscellaneous Installation Installing Camera Utility SoftwareTransferring Images to a PC Macintosh Miscellaneous Connecting the Camera to a PC Beep Sound Setting Changing Camera SettingsPress the or button to select Beep Press the Enter button to select OFF Auto Power Off Setting How To reset settingsPress the or button to select Auto Keep Settings Formatting Internal Memory After confirming the setting, press the Menu button Changing OSD On-Screen Display Language Changing Video-Out Signal Method NTSC/PAL Restoring the Setting Changing LCD ConfirmationPress the or button to select LCD Changing the LCD Setting Initializing Settings With sequential numbering on initial setting When continuous numbering is offChanging File Names Use the up or down button to select Use the up or down button to select Display → Power Checking the Version Rotate the mode dial toPress the Enter button to select on After checking the version, press the Menu button Using the Remote Control Setting Exposure Compensation Shooting in Manual Focus ModePlaying Magnifying an Image Zoom Playback Canceling the mode settingDisplaying Multiple Images Multi Image Playback Moving the playback position Clearing all files Deleting multiple filesErasing the files Model Remarks Accessories Potential Causes of Condensation Handling Precautions Care and Storage CareStorage Troubleshooting Power SourceRecording and Playback 122 123 Ricoh AC-3 AC adapter optional Using a Local TV Receiver for Playing Pictures 125 About the Warranty and Servicing 126 Specifications Power Supply Main Batteries Image Data Recording and Playback Image ResolutionDate backup battery Auto Power-Off Recording Capacities Type PIC Mode USA FCC Part15 Class B Information to the User Ricoh Service Offices