Note • A flashing AF indication LED indicates that the subject is out of focus. If this occurs, use the focus lock function. See “Focus Lock Shooting” (p.62).
•If the “SLOW SHUTTER” message appears on the LCD monitor, you are recommended to shoot with the flash enabled or in S mode to avoid camera shake that tends to occur in this situation. See “Changing Flash Modes” (p.55) and “S Mode (Shutter Speed)” (p.71).
r Press the shutter release button down |
| ||
fully without removing your finger. |
| ||
A beep will sound and the picture will be taken. |
| ||
Note • If the camera is moved before the | 2 | ||
buzzer sounds, blurring may occur. | |||
• If recording fails, the buzzer will | |||
produce a beeping sound. In such | Basic | ||
cases, take the photograph again. | |||
Shooting | |||
saved to the memory inside the camera and are then recorded when picture taking | |||
● Quick shooting mode [ | ] |
| |
As long as the release button is pressed, frames will be photographed at the rate of |
| ||
approximately one frame per second. The photographed images are temporarily |
| ||
is completed. |
|
| |
Picture taking stops when the finger is removed from the release button. The |
| ||
images photographed up to that point are temporarily saved to the memory inside |
| ||
the camera. When the release button is again pressed, the remaining frames will |
| ||
be exposed. The images stored inside the camera are recorded when the following |
| ||
occur. |
|
| |
•When the MENU button, PIC button or CARD/IN button is pressed
•When the mode dial is rotated
•When the power is turned off (AF lamp and flash lamp blinking) When there is no operation for 30 sec. after an exposure is made
•When the number of frames remaining is zero (0)/when all frames have been
exposed
• When the [
] mark appears on the LCD monitor
● Still frame mode ( 
)/text mode ( 
)
When the release button is fully pressed, a photograph is taken and recorded. When set for the image to appear on the LCD monitor, the image will first be displayed and then recorded. Recording can be started immediately by pressing the ▼ or ▲ button. See “Changing LCD Confirmation”.
While the image is being displayed on the LCD monitor, recording can be canceled by pressing the MENU button. Messages are displayed during recording, so press the ENTER button.
ABORT RECORDING
ABORT : ENTER
CANCEL: MENU
49
