Ricoh RDC-5300 manual Using the Remote Control, Shooting

Using the Remote Control

The DR-3 remote control unit (optional) makes it possible to record and play back images from a remote location.

Important

Note

Note

•The remote control receiver is located on the right side of the lens. Operate the remote control unit by pointing it at the remote control receiver.

•For instructions on replacing the batteries and maintaining the remote control unit, refer to the accompanying manual.

•Some procedures differ when performed on the remote control unit and on the camera itself. Follow the instructions below to use the remote control unit.

Shooting

The remote control unit can be used to operate the camera. It is particularly convenient when the camera is set up at a remote location or is in a fixed position.

q Set the mode dial to [ ] and press the

CARD/IN button to select a recording destination.

wDecide the composition of the picture and press the RELEASE button on the

remote control unit.

When the camera is set to the Still mode, the self-timer lamp will blink and recording will start approximately 2 sec. later. In the Continuous mode, recording will start immediately after the RELEASE button is pressed.

Note • Use the zoom buttons to vary the size

of the subject. The button

magnifies the subject (telephoto), while

the button decreases the size of

the subject (wide angle).

R E L E ASE

ERASE F WD PROGR AM

E V

ENTER

RE V

MULTI

114