FRONT RIGGINGS

PROCEDURE 3

This Procedure Includes the Following:

Wheelchair Frame

Installing/Removing Footrests

Adjusting Footrest Height

Replacing Heel Loops

Installing/Removing Elevating Legrests

Raising/Lowering Elevating Legrests and/or Adjusting Calfpads

Adjusting/Replacing Telescoping Front

Hinge

Footrest

Release

Lever

Footrest

F R O N T

R

I

Rigging Support

Adjusting Removable Footboard

Removing the Removable Footboard Assembly from the Wheelchair

Installing/Removing the One Piece Footboard

Adjusting the One Piece Footboard - Height, Angle and Depth

Removing/Installing the Calf-Pads

Adjusting the Calf-Pads

Footrest Angle Adjustments

Pins

Hinge

Plate

FIGURE 1 - INSTALLING/REMOVING FOOTRESTS

Removing

1.Push the footrest release lever inward and rotate the footrest outward.

2.Lift up on the footrest and remove from the wheel- chair.

3.Repeat STEPS 1-2 for the opposite side of the wheel- chair.

G G I N G S

WARNING

After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

NOTE: Some footrests may require the use of two (2) hands to install/remove from the wheelchair.

INSTALLING/REMOVING

FOOTRESTS (FIGURE 1)

Installing

1.Turn the footrest to the side (open footplate is perpendicular to wheelchair) and position the mounting holes in the footrest hinge plates with the hinge pins on the wheelchair frame.

2.Install the footrest hinge plates onto the hinge pins on the wheelchair frame.

3.Push the footrest towards the inside of the wheel- chair until it locks into place.

NOTE: The footplate will be on the inside of the wheel- chair when locked in place.

4. Repeat STEPS 1-3 for opposite side of wheelchair.

ADJUSTING FOOTREST HEIGHT

All Footrests Except Model P93M Footrests (FIGURE 2)

1.Remove any accessory from the footrest(s).

2.Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVING FOOTRESTS in this pro- cedure of the manual.

NOTE: Lay the footrest on a flat surface to simplify this procedure.

3.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

4.Reposition the lower footrest to the desired height.

5.Reinstall the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support and tighten securely.

6.Repeat STEPS 1-5 for the opposite side of the wheel- chair footrest, if necessary.

7.Reinstall the footrest(s) onto the wheelchair. Refer to INSTALLING/REMOVING FOOTRESTS in this procedure of the manual.

8.Reinstall any accessory onto the footrest(s).

15

Page 15
Image 15
Invacare R2-250, Pronto R2 INSTALLING/REMOVING Footrests Figure, Adjusting Footrest Height, Front Riggings, O N T, I N G S