PROCEDURE 3 | FRONT RIGGINGS |
F R O N T
R
I
G G I N G S
INSTALLING/REMOVING THE ONE PIECE FOOTBOARD (FIGURE 12)
Installing the One Piece Footboard
1.Pull the detent pin out from the support assembly.
2.While pulling detent pin, insert the legrest tube of the one piece footboard assembly into the support assembly.
WARNING
Before operating the wheelchair, ensure de- tent pin is engaged, and adjustment lever is securely tightened, otherwise, injury and/or damage may result.
3.Visually inspect and ensure that the detent pin is engaged.
4.Ensure pull ring is resting on the hex head portion of the detent pin assembly. Refer to DETAIL “A”.
5.Securely tighten the adjustment lever.
Removing the One Piece Footboard
1.Loosen, but DO NOT remove, the adjustment le- ver from the support assembly.
2.Pull the detent pin from the support assembly.
3.While pulling the detent pin, remove the one piece footboard assembly from the support assembly.
DETAIL “A” | Detent Pin |
Seat | Assembly |
Frame |
|
Hex Head | Pull | |
portion of | ||
Ring | ||
Pull Ring | ||
|
Legrest
SupportTube
Assembly
Adjustment
Lever
FIGURE 12 - INSTALLING/REMOVING THE ONE
PIECE FOOTBOARD
ADJUSTING THE ONE PIECE FOOTBOARD - HEIGHT, ANGLE, AND DEPTH
Height (FIGURE 13)
1.Remove the two (2) hub caps that cover the mount- ing bolt of the footboard assembly.
2.Remove the mounting bolt, locknut, two (2) caplug washers, two (2) large washers, and two (2) spac- ers that secure the footboard assembly to the legrest tube.
3.Raise or lower the footboard assembly to the de- sired mounting position on the legrest tube.
NOTE: Do NOT cover the warning label on the legrest tube shown in FIGURE 13.
4.Secure the footboard assembly to the legrest tube in the position determined in STEP 3 with the mounting bolt, two (2) cap caplug washers, two
(2)large washers, two (2) spacers and locknut. Securely tighten.
5.Replace the two (2) hub caps.
Spacers (Not Shown are positioned between the legrest tube and the
footboard assembly.)
Warning Label
Mounting
Bolt Hub Cap
Large
WasherCaplug
Washer
Locknut | Large |
Washer | |
| Footboard |
Hub Cap | Caplug Washer |
FIGURE 13 - ADJUSTING THE FOOTBOARD HEIGHT
Angle (FIGURES 14 AND 15)
1.Loosen, DO NOT remove, the four (4) flat head screws and barrel nuts that secure the footboard to the two (2) half clamps.
2.Rotate the two (2) half clamps on the pivot hinge until the desired angle is achieved.
3.Securely tighten the four (4) flat head screws to the footboard and half clamps.
20
