Invacare Pronto R2 manual Repositioning Mkiv Joystick, Preparing Mkiv Joystick for USE Figure, E C

PROCEDURE 6

E L E C

This Procedure Includes the Following:

Preparing MKIV Joystick for Use Repositioning MKIV Joystick Repositioning Battery Charger Connector Fuse Replacement

REPOSITIONING MKIV JOYSTICK

Adjustable Seat Back Angle/Recliner Seat Models (FIGURE 2)

1.Turn the lever on the adjustment lock to release the adjustment lock from joystick mounting tube (tube).

2.Remove the joystick from the wheelchair.

T R O N I C S

WARNING

AfterANYadjustments,repairorserviceandBEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

PREPARING MKIV JOYSTICK FOR USE (FIGURE 1)

NOTE: The MKIV joystick is factory installed on the right side of the wheelchair. To reposition the MKIV joystick onto the left side of the wheelchair, perform one (1) of the following: AD-

JUSTABLESEATBACKANGLE/RECLINERSEAT-RE- POSITIONING MKIV JOYSTICK in this procedure of the manual or CAPTAIN'S SEAT MODEL WHEELCHAIRS - have the joystick repositioned by a qualified technician.

1.Turn the lever on the adjustment lock to release the adjustment lock from joystick mounting tube.

2.Slide joystick mounting tube to the desired position.

3.Turn the lever on the adjustment lock to secure the adjustment lock to the joystick mounting tube.

MKIV Joystick

3.Remove the three (3) hex screws that secure joystick mounting bracket (bracket), the threaded hole half clamp and the opened hole half clamp to the arm tube.

4.Reposition the threaded hole half clamp and opened hole half clamp on the opposite arm tube. Make sure threaded hole half clamp is on the inside of arm tube.

5.While holding the two (2) half clamps, install the front hex screw into the two (2) half clamps. Securely tighten.

6.Line up mounting holes of the joystick mounting bracket with the mounting holes in the two (2) half clamps.

7.Secure the joystick mounting bracket to the two (2) half clamps with the remaining two (2) hex screws.

8.Slide tube through the bracket to the desired position.

9.Slide adjustment lock over end of tube and secure ad- justment lock to tube by turning lever on adjustment lock.

NOTE: If adjustment lock does not fit over tube, rotate 180o.

Threaded Hole Half Clamp

Arm Tube

Joystick

	Adjustment	Joystick Mounting Tube
Joystick		Hex Screws
	Lock

MountingTube	Joystick Mounting Bracket
FIGURE 1 - PREPARING MKIV JOYSTICK FOR USE	Adjustment Lock
	Opened Hole Half Clamp
	FIGURE 2 - REPOSITIONING MKIV JOYSTICK -
	ADJUSTABLE SEAT BACK ANGLE/RECLINER SEAT
	MODELS

30