Jenn-Air JES8850 manual Troubleshooting, Oven Door, Nothing will operate, Cooktop will not operate

Models: JES8850 JES8750 JES8860

1 64
Download 64 pages 9.18 Kb
Page 26
Image 26
Oven Door

Warming Drawer

(on some models)

Remove all items from inside the warming drawer, and allow the warming drawer to cool completely before attempting to remove the drawer.

To Remove:

1.Open drawer to its fully open position.

2.Locate the black loops on both sides of the drawer.

ATROUBLESHOOTING

A. Loop

3.Pull both loops forward at the same time, then pull drawer out another inch.

4.Holding the drawer by its sides, not its front, gently pull it all the way out.

To Replace:

1.Align the drawer glides with the receiving guides.

2.Push drawer in all the way.

3.Gently open and close the drawer to ensure it is seated properly on the slides.

Oven Door

For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

1.Open oven door to the first stop position (opened about 4" [10.0 cm]).

2.Grasp door at each side. Do not use the door handle to lift door.

3.Lift up evenly until door clears hinge arms.

To Replace:

1. Grasp door at each side.

2. Align slots in the door with the hinge arms on the range.

3. Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

 

Hot surface indicator light stays on

Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Does the hot surface indicator light stay on after controls have been turned off? See “Hot Surface Indicator Light” in “Cooktop Controls” section.

Cooktop will not operate

Is the control knob set correctly? Push in knob before turning to a setting.

Excessive heat around cookware on cooktop

Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.

Cooktop cooking results not what expected

Is the proper cookware being used? See “Cookware” section.

Is the control knob set to the proper heat level? See “Cooktop Use” section.

Is the range level? Level the range. See the Installation Instructions.

26

Page 26
Image 26
Jenn-Air JES8850 Troubleshooting, Oven Door, Nothing will operate, Hot surface indicator light stays on, Warming Drawer