
To attach the wire whip, flat beater or dough hook
WARNING
Injury Hazard – Unplug mixer before inserting or removing attachments. Failure to do so may result in broken bones or cuts.
1. Make sure that the touch wheel control is set to “OFF” and the mixer is unplugged.
2. Press the mixer head release button and lift the mixer head up until it locks into place.
3. Insert desired attachment onto attachment post and press upward as far as possible.
4.Turn the attachment clockwise, hooking the attachment to the post.
5.Be sure the bowl is attached to the mixer before operat- ing (see page 7).
6.Lower the mixer head by pressing the mixer head release
button and guiding the mixer head down carefully with your hands.
7.Plug power cord into a grounded
8.Your mixer is adjusted at the factory so that the flat beater just clears the bot- tom of the bowl. Should the flat beater strike the bottom of the bowl or is too far away from the bowl, clearance can be corrected as follows:
•Lift mixer head.
•Turn the mixer head adjustment screw counterclock-
wise to raise the head and clockwise to lower the head.
• Make this adjustment using the flat beater until it just clears the bottom of the bowl.
Adjustment Screw
8