•Preform wires to the appropriate shape to suit fitting into the mains terminal block.
•Strip inner insulation on wires using wire strippers.
•Twist the bared wires using pliers.
•Cut bared wires 10mm away from the end of the inner insulation. Where uninsulated Earth wires are used ensure they are suitably sheathed to leave 10mm bare wire to fit into the terminal.
•Clamp bare wires into the relevant terminal and check they are held by tugging each one in turn.
•Clamp the mains cable securely ensuring 5mm of the outer insulation is inside the terminal block and that the wires are not taut but not so slack as to cause any fouling. See diagram.
•Place fuse/miniature circuit breaker in circuit and switch on at mains.
Checking electrical connections
Correct electrical connection can be confirmed when switching on the appliance as the timer will be flashing.
Important! House circuit Earth leakage and continuity tests must be carried out before the appliance is connected to the mains
Connecting to a hob or cooker point
Either follow in general terms the instructions for connecting to the terminal block or refer to the hob suppliers installation instructions.
Warning! Feed the cable through the cabinet and arrange to route the cable away from the appliance which may become hot.
Fitting into the cabinet
Warning! IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.
•Using a tape measure establish the internal width of the cabinet. Refer to recommended cabinet dimensions diagram if greater than 565mm.
•Position the appliance in front of the cabinet. Mains cable
Mains cable
•Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.
45
