Putting the door glass panels back.
1.From above insert the door glass panels one after the other into the door profile at the bottom edge of the door at an angle and lower them.
3The two smaller panels first, then the larger panel.
2.Take hold of the door trim (B) at each side, position it on the inside edge of the door and plug the door trim (B) into the upper edge of the door.
3On the open side of the door trim (B) there is a guide bar (C). This must be pushed between the outer door panel and the guide corner (D).
The clip seal (E) must be snapped in.
3. Open the oven door as far as it will go.
49
