Mobile Home Installation
The Jøtul GF 200 DV Lillehamme can be installed for use in a mobile home in the U.S. and Canada pro- vided:
1.The stove is secured to the floor of the mobile home. Use Jøtul Floor Mounting Kit #154342.
2.The stove is installed in accordance with Title 24 CFR, Part 3280- Manufactured Home Construction and Safety Standard, in the U.S. Comply with CSA Z240.4, Gas Equipped Recreational Vehicles and Mobile Housing, in Canada.
3.Always contact your local building code officials about installation restrictions and specific require- ments in your area.
THIS APPLIANCE MAY BE INSTALLED AS AN OEM INSTALLATION IN A MANUFAC- TURED (MOBILE) HOME AND MUST BE INSTALLED IN ACCORDANCE WITH THE MAUFACTURER’S INSTRUCTIONS AND THE MANUFACTURED HOME CONSTRUCTION AND SAFETY STANDARD, TITLE 24 CFR, PART 3280. THIS APPLIANCE IS ONLY FOR USE WITH THE TYPE OF GAS THAT IS INDICATED ON THE STOVE’S RATING PLATE. A GAS CONVERSION KIT IS PRO- VIDED WITH THE LILLEHAMMER DIRECT VENT GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN AFTERMARKET PERMANENTLY LOCATED, MANUFACTURED (MOBILE) HOME, WHERE NOT PROHIBITED BY LOCAL CODES.
CET APPAREIL PEUT ETRE INSTALLE DANS UN MAISON PREFABRIQUEE (MOBILE) DEJA INSTALLEE A DEMEURE SI LES REGLEMENTS LOCAUX LE PERMETTENT. CET APPAREIL DOIT ETRE UTILISE UNIQUEMENT AVEC LES TYPES DE GAS INDIQUES SUR LA PLAQUE SIGNALETIQUE. NE PAS L’UTILISER AVEC D’AUTRES GAS SAUF SI UN KITDE CONVERSION CERTIFIE EST INSTALLE.
Gas Conversion
The Jøtul GF 200 DV Lillehammer gas stove is shipped from the factory equipped to burn NATU- RAL GAS. Install the Fuel Conversion Kit, included with the stove, if Propane use is necessary. The kit contains all the necessary components needed for safe conversion and includes appropriate conversion notice labels.
WARNING:
THE CONVERSION KIT IS TO BE IN- STALLED BY AN AUTHORIZED JØTUL SERVICE TECHNICIAN IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUC- TION AND ALL CODES AND REQUIRE- MENTS OF THE AUTHORITY HAVING JURISDICTION. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. THE QUALIFIED AGENCY PERFORMING THIS WORK ASSUMES RESPONSIBILTY FOR THIS CONVER- SION.
Tools Required:
•1/4” Nut driver
•7/16” and 1/2” open end wrench
•Torx
Fuel Conversion Kit Contents:
•1 regulator tower labeled for Propane
•3 regulator tower screws
•1 burner orifice (#48 for NG, 3/64 for LPG)
•1 pilot orifice (#51 for NG, #30 for LPG)
•Label A - to be completed and applied to the back of the stove.
•Label B - to be applied to the stove Rating Plate.
•Small valve label - apply to the Control Valve body.
Conversion instructions are also included in the conversion kit.
Canadian Requirements
THE CONVERSION SHALL BE CARRIED OUT IN ACCORDANCE WITH THE REQUIREMENTS OF THE PROVINCIAL AUTHORITIES HAVING JURISDICTION AND IN ACCORDANCE WITH THE REQUIREMENTS OF THE
AND .2 INSTALLATION CODE.
15
