Maintenance
The GF 200 DV Lillehamer gas stove and its venting system should be inspected before use and at least annually by a qualified service technician.
IMPORTANT:
ALWAYS TURN OFF THE GAS SUPPLY TO THE STOVE BEFORE ANY SERVICE WORK IS PERFORMED ON THE STOVE.
General cleaning: The firebox should be vacuumed out annually to remove any surface build up. Be sure to vacuum or wipe off the pilot assembly and burner orifice and burner tube. Also, when vacu- uming the log set, be sure to handle it carefully as it is very fragile.
Gasket inspection: It is important that the glass gasket be inspected at least annually. Examine the rope gasket for signs of deterioration and make sure the gasket has a positive seal. This is impor- tant to prevent combustion gases from escaping into the room. Replace the gasket if necessary, refer to the replacement parts list on page 25.
Always replace any damaged or broken parts with JØTUL AUTHORIZED PARTS ONLY. These are available through your Jøtul dealer. Never use any substitute parts on your Lillehammer Direct Vent stove.
With proper care and maintenance, your Jøtul gas stove will provide you with many years of service. If you experience any problems with Jøtul GF 200 DV, contact your authorized Jøtul dealer for assistance.
Fill out the Maintenance Record form on the next page and keep it up to date. It will provide useful information of service activity to help you and your dealer keep your stove in top condition.
Glass Front
Do not operate the Lillehammer gas stove with the glass front removed, cracked or broken. Replace- ment of the glass should be done by a licensed or qualified service person. Only remove glass for routine service. Always handle glass carefully.
Glass and Gasket Replacement
1.Using a nail punch inserted into the perf holes, carefully pry the two glass retainer tabs back. See fig. 27.
2.Peel away all remnants of the old gasket material and clean any adhesive residue off the glass.
3.Peel the paper backing off the replacement gasket to expose the adhesive.
4.Apply the gasket to the panel, wrapping the adhesive side down around the panel edge. See fig. 28.
5.Insert the gasketed glass panel into the frame and use the nail punch to bend the retainer tabs over the edge.
Bend Tab back
Figure 27. Glass removal.
RETAIN THIS MANUAL FOR REFERENCE
AND MAKE IT AVAILABLE TO ANYONE
USING OR SERVICING THE STOVE.
WARNING: OBSERVE CAUTION NEAR THE
GLASS. THE GLASS PANEL MAY SHATTER
UNEXPECTEDLY IF STRUCK WITH AN
OBJECT. ALWAYS HANDLE THE GLASS
PANEL WITH CARE. WHEN SERVICING THE
STOVE ALWAYS PULL THE GLASS ASSEM-
BLY STRAIGHT UP FOR REMOVAL.
Figure 28. Glass gasket replacement.
23
