Basic Settings
English
Amplifier/TunerDISPLAY PATTERN
MULTI JOG
CONTRAST CLOCK/TIMER CANCEL SET (DISPLAY/CHARA.)
Before operating the unit any further, first set the clock built in this unit, then some other basic settings.
Setting the Clock
You can set the clock whether the unit is turned on or in standby mode.
1 Press CLOCK/TIMER.
The hour digit in the main display starts flashing.
2 Rotate MULTI JOG to adjust the hour, then press SET.
• If you want to correct the hour after pressing SET, press CANCEL. The hour digit starts flashing again.
3 Rotate MULTI JOG to adjust the minute, then press SET.
After completing the clock setting...
The analog clock in the display window shows the current time. This analog clock advances its long hand twice every 5 minutes. (When 3 minutes pass, it advances once. Then 2 minutes pass, it advances again.)
Changing the Display Pattern
To change the display pattern of the audio level indicator
The audio level indicator appears in the main display only while playing a source.
Press 1, 2 or 3.
•1: For the following pattern:
•2: For the following pattern:
•3: For erasing the audio level indicator:
The audio level indicator is not shown, and other indications — the disc number or track number, playing time — become enlarged in the main display. To restore the previous audio level indicator, press 3 again. (The other indications in the main display are diminished.)
To dim the display window
Press DIMMER.
Each time you press the button, the display window and the MULTI JOG dial dim and brighten alternately.
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the clock again.
To start the display demonstration
Press DEMO.
• If the unit is in standby mode, the power turns on automatically.
To stop the demonstration, press any button. “DEMO
OFF” appears.
To adjust the contrast of the display window
1Press and hold CONTRAST (DISPLAY/CHARA.) for more than 2 seconds.
The contrast adjustment display appears.
2Rotate MULTI JOG to adjust the contrast.
After completing contrast adjustment...
Pressing any button restores the previous display.