Symptom |
Possible Cause |
| Action |
|
| Tracks cannot be joined. |
HDD editing |
|
|
When playing back the joined | ||
|
| portion, you will hear noise. |
|
|
|
|
|
|
•These tracks are recorded in different recording modes or in different albums.
•The total playing time of the joined track exceeds 3 hours in the Linear PCM format or 24 hours in the AAC format.
You have joined some tracks recorded from a live CD.
•This is normal. You cannot join these tracks.
•This is normal. The total playing time of a track cannot exceed these hours.
If the tracks have been recorded digitally, this cannot be avoided. To avoid this, use analog recording method when recording these tracks (see page 51). Then join them later.
Mechanical noises are heard and |
the cabinet slightly vibrates. |
No sound is heard. |
The hard disk is constantly rotating at | This is normal. | |
high speed when the power is on, |
|
|
causing imperceptible mechanical |
|
|
noises and cabinet vibration. |
|
|
|
|
|
Connections are incorrect or loose. | Check all connections and make | |
| corrections (see pages 6 to 9). | |
|
|
|
General | Unable to operate the remote |
control. | |
| |
|
|
| If “ERROR” appears in the main |
| display. |
|
|
•The path between the remote control and the remote sensor on the unit is blocked.
•The batteries have lost their charge.
•You are using the remote control far from the main unit.
Something is wrong with your unit.
•Remove the obstruction.
•Replace the batteries (see page 9).
•Signals cannot reach the remote sensor. Move closer to the main unit.
Unplug the unit immediately, then consult your dealer.
If “ERROR! SPK DC OUT” |
appears in the main display and no |
sounds come from the speaker. |
External keyboard does not work |
at all. |
Operations are disabled. |
The volume is too high.
The keyboard is not fully discharged electrically.
The
Turn off the unit and unplug it, then consult your dealer.
Turn off the unit, then turn it on back again after a while.
Press REC START and 0CD on the unit at the same time, or unplug the unit then plug it back in. (See “CAUTION” below.)
DO NOT press REC START and 0CD on the unit at the same time, or do not unplug the unit then plug it back in while recording, compressing (Smart Compression) or editing the data in the HDD; otherwise, the data will be damaged.