JVC DLA-QX1G manual Remove the slot panel from the slot, Projector, Install the VIC

Connector Panel (Cont.)

About the optional VICs

HDTV Analog VIC

ÅLED

This LED lights up when the HDTV Analog VIC is selected.

ıY, Pb, Pr input terminal (BNC x 3)

These are Y, Pb, Pr input terminals for HD signal (SMPTE260M/274M/296M).

HD-SDI VIC

ÅLED

This LED lights up when the HD-SDI VIC is se- lected.

ıSDI input/output (through) terminal (BNC x 2) These are input and output terminals for HD-SDI signal (SMPTE292M).

Å

HDTV Analog VIC

Y Pb Pr

ı

Åı

HD-SDI VIC

INOUT

How to install the optional VICs

1 Remove the slot panel from the slot of the			OUT	RS-232C
projector.		NTROL	REMOTE	R
			-232C
1) Remove two screws on the slot panel, one on each end,	CO		B Y
		VIC		H/C
			G
from an empty slot.		Analog
	RGB

2) Take off the slot panel.

ENGLISH

2Install the VIC.

1)Aligning both ends of the PC board of the VIC with the grooves inside the slot, insert the VIC into the slot.

2)Push the VIC fully so that two connectors on inner surface of the VIC are securely plugged into the sockets inside the slot.

3Fasten the VIC to the projector.

After inserting the VIC into the slot, fasten it to the projector with two screws attached to the VIC.

				RS-232C
			C O	UT
			232
	REM	OTE
CONTROL				R
			G	H/C
VIC		B	Y
Analog
RGB

P

	VIC	P
	Analog	Y
HD	TV

				RS-232C
			OUT
			-232C
CONTROL	REMOTE			B
			G	H/C
	VIC	R	Y
Analog
RGB
			P
	VIC		P
Analog		Y
HDTV

Notes

•To avoid penetrating of the dust, do not remove the slot panel from the unused VIC slot.

• When replacing the slot panel, set it with the arrow up (indicated on the both ends of the slot panel) as shown:

arrow

13