JVC DR-MV5BEK, DR-MV5SEK manual Remote Control Functions, Remote Control 1/2/3/4 Code Switching

Filename [MV5SEK_12RemoSys.fm]

	Masterpage:Left0
MV5SEK_00.book Page 74 Wednesday, August 31, 2005 7:58 PM

74 EN REMOTE CONTROL

		Remote Control Functions	● Keep pressing SET UP down during step 1.
			1 Press the number button “1” for 1, “2” for 2, “3” for 3 or “4”
			for 4 to change the remote control code, then press ENTER.
Remote Control 1/2/3/4 Code Switching
			2 Press 1 on the unit to turn off the unit.
			3 Press 4 on the unit for over 5 seconds while the unit is turned
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four codes			off. The code currently set appears on the front display panel.
(1, 2, 3 or 4). The remote control is preset to send 3 code signals			4 Press 8 on the remote control to change the unit’s code. The
because your unit is initially set to respond to 3 code signals. You			code currently set on the remote control blinks on the front display
can easily modify your unit to respond to 1, 2 or 4 code signals.
			panel for approximately 5 seconds, and is applied to the unit.
			NOTE:
	● Slide the TV/DVD switch to DVD.
			Even when “POWER SAVE” is set to “ON” ( pg. 79), it is possible to
			change the remote code.

STANDBY/ON		VHS	DVD		REC
			VHS/DVD		PR
S-VIDEO	VIDEO	AUDIO
			VHS	DUBBING	DVD
					DV IN

1 – 4

ENTER

SET UP

Page 74

Wednesday, 31 August 2005 19:58