JVC DR-MV5SEK, DR-MV5BEK manual Auto Set Up, Number Set, Vhs Dvd, Enter SET UP

SET UP

EXIT

Filename [MV5SEK_05Name.fm]
MV5SEK_00.book Page 17 Wednesday, August 31, 2005 7:58 PM	Masterpage:Right0
	INITIAL SETTINGS EN 17

	Auto Set Up	ATTENTION:
		Once you have performed Auto Set Up, even if the unit’s memory
Auto Channel Set/Auto Clock Set/Auto Guide Program		backup has expired, all the stored stations and their Guide
		Program numbers remain in the unit’s memory and the unit will
Number Set		not perform Auto Set Up again. The unit only performs Auto
		Clock Set when the unit is turned on.
		If you have moved to a different area, perform each setting as
After the 1 button on the unit or remote control is pressed for		required.
the first time to turn on the unit, the Auto Set Up function sets the		● Tuner setting ( pg. 84)
tuner channels, clock and Guide Program numbers		● Clock setting ( pg. 88)
automatically.		If a new station starts broadcasting in your area, perform tunesr
		setting. ( pg. 84)

		NOTES:
		● In areas where no TV station transmits a PDC (Programme Delivery
		Control) signal, the unit can perform neither Auto Clock Set nor Auto
		Guide Program Number Set.
VHS	DVD	● If there is a power cut, or if you press 1 or SET UP while Auto Set
		Up is in progress, Auto Set Up will be interrupted; be sure to turn off
		the unit power once and try again from step 1.
		● Auto Clock Set may not function properly depending on the reception
		condition.
		After “Auto Set Up” is completed, perform “Monitor Set (DVD
		Deck Only)” on page 21.

ENTER

SET UP

Before starting, make sure of the following:

●The TV aerial cable should be connected to the unit.

●The unit’s AC power cord should be connected to a AC outlet.

●Turn on the TV and select the AV mode.

●Slide the TV/DVD switch to DVD.

1 Press 1 to turn on the unit. The AUTO SET/T-V LINK display appears on the TV screen.

2 Press rt to select “AUTO SET”, then press ENTER. The AUTO SET screen will appear, and the unit automatically performs Auto Channel Set.

INITIAL SET UP

INITIAL SET UP / CHANNEL SET

AUTO SET

T-V LINK

● When Auto Channel Set is completed, “PLEASE WAIT” will

OK

be displayed for about 90

SELECT

seconds, since channel data is exchanged between the DVD

deck and the VHS deck. No operation will be done

SELECT WITH [CURSORS] THEN PRESS [ENTER]

during this time.

ATTENTION:

●When you have connected the unit to a TV offering T-V Link via a fully-wired 21-pin SCART cable ( pg. 15) and the TV is turned on, the unit automatically performs the Preset Download ( pg. 18) even if you select “AUTO SET” for Auto Set Up function.

INITIAL SET UP

INITIAL SET UP / CHANNEL SET

AUTO SET		AUTO SET
T-V LINK
		PLEASE WAIT...
			CANCEL
SET UP	OK		SELECT WITH [CURSORS]
EXIT	SELECT		THEN PRESS [ENTER]

Page 17

Wednesday, 31 August 2005 19:58