JVC DR-MV5SEK, DR-MV5BEK manual When using your unit as the source player

Filename [MV5SEK_08Basic TimerDub.fm]
MV5SEK_00.book Page 43 Wednesday, August 31, 2005 7:58 PM	Masterpage:Right+

EDITING EN 43

	Edit To Or From Another Recorder	Slide the TV/DVD switch to DVD.
		1 Connect the player’s 21-pin SCART connector to the unit’s 21-
You can use your unit as the source player or as the recording
		pin SCART connector as illustrated.
deck.
		A When using your unit as the source player:

NOTE:			— connect its [L-1 IN/OUT] connector to the recording deck.
When using another recorder as the recording deck, refer to its			B When using your unit as the recording deck:
instruction manual.			— connect its [L-1 IN/OUT] or [L-2 IN/DECODER] connector to
A When using your unit as the source player:			the source player.
			● If another recorder is compatible with the Y/C signal (DVD deck only):
			— when using your unit as the source player, set “L-1 OUTPUT” to
TV receiver	Player	Your unit	“SCART S-VIDEO”. ( pg. 44)
			— when using your unit as the recording deck, set “L-2 SELECT” to
			“S-VIDEO/RGB”. ( pg. 45)
			2 Press VHS/DVD repeatedly to select the recording deck.
			3 Press PR +/– to select “L-1” for the [L-1 IN/OUT] connector, or
			“L-2” for the [L-2 IN/DECODER] connector, depending on the
			connector being used when using this unit as the recording deck.
		21-pin SCART cable (provided)	For DVD deck
			● When using the [L-1 IN/OUT] connector, set “L-1 OUTPUT” to
21-pin SCART cable			“VIDEO” or “S-VIDEO”. ( pg. 44)
(not provided)			● When using the [L-2 IN/DECODER] connector, set “L-2 SELECT” to
			“VIDEO/RGB” or “S-VIDEO/RGB”. ( pg. 45)
			4 Press REC MODE repeatedly to set the recording mode.
		Another recorder	5 Engage the Play mode of the source player.
			6 Engage the Record mode of the recording deck.
	Recorder		7 Stop recording on the recording deck, then stop playback on the
			source player.

BWhen using your unit as the recording deck:

TV receiver Recorder Your unit

21-pin SCART cable (provided)

21-pin SCART cable (not provided)

NOTES:

●All necessary cables can be obtained from your dealer.

●For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

●When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to “OFF” before starting. ( pg. 79)

●If you are using another recorder with S-Video and Audio output connectors, connect its S-Video and Audio output connectors to this unit’s [S-VIDEO] and [AUDIO] input connectors on the front panel. Then, set the unit’s input mode to “F-1” in step 3, and set “F-1 INPUT” to “S-VIDEO”. ( pg. 45) (DVD deck only)

Another recorder

Player

Page 43Wednesday, 31 August 2005 19:58