JVC DR-MV5BEK manual Connecting/Using a Decoder DVD Deck Only, Connecting To a Satellite Receiver

Filename [MV5SEK_12RemoSys.fm]
MV5SEK_00.book Page 76 Wednesday, August 31, 2005 7:58 PM	Masterpage:Left0

76 EN SYSTEM CONNECTIONS

Connecting To A Satellite Receiver

Connect the satellite receiver to the [L-2 IN/DECODER] connector, then connect the [L-1 IN/OUT] connector to the TV’s connector.

NOTES:

●Set “L-2 SELECT” to “VIDEO/RGB” or “S-VIDEO/RGB”. ( pg. 45)

●You can use the Automatic Satellite Programme Recording function ( pg. 36) with this connection. (DVD deck only)

●To record a programme via the satellite receiver, select L-2 mode by pressing PR +/– so that “L-2” appears on the front display panel.

●For details, refer to the instruction manual of the satellite receiver.

Outdoor unit Aerial

Connecting/Using A Decoder (DVD Deck Only)

The [L-2 IN/DECODER] connector can be used as an input connector for an external decoder (descrambler). Simply connect a decoder and you can enjoy a variety of programming that is available through scrambled channels.

Decoder

TV aerial cable

Satellite cable

Satellite receiver

TV aerial cable	L-1 IN/OUT
TV
ANTENNA IN
ANTENNA OUT
	L-2 IN/
	DECODER

RF cable (provided)

TV

1 Set “L-2 SELECT” to “DECODER”. ( pg. 45)

2 Connect your unit’s [L-2 IN/DECODER] connector to the decoder’s 21-pin SCART connector using a 21-pin SCART cable.

IMPORTANT

When you set “L-2 SELECT” to “SAT VIDEO/RGB” ( pg. 45), it is possible to view a satellite broadcast with the TV set to its AV mode even if the unit is turned off. When the unit is in Stop mode or recording, press TV/VIDEO on the remote control to turn off the video indicator ( ) on the unit.

●If you turn on the unit when the satellite receiver’s power is off, nothing appears on the TV screen. In this case, turn on the satellite receiver, or set the TV to its TV mode, or press TV/VIDEO on the remote control to set the unit to the AV mode.

Page 76

Wednesday, 31 August 2005 19:58