JVC DR-MV5SEK, DR-MV5BEK manual When you can’t switch the audio channel of a bilingual, Programme

Filename [MV5SEK_12RemoSys.fm]
MV5SEK_00.book Page 77 Wednesday, August 31, 2005 7:58 PM	Masterpage:Right+

	SYSTEM CONNECTIONS EN 77
Connecting To A Dolby Digital Decoder	When you can’t switch the audio channel of a bilingual
	programme
Or An Amplifier With Built-in DTS	When the unit is connected with a digital audio device using an
	optional coaxial cable and “DIGITAL AUDIO OUT” is set to
	“DOLBY DIGITAL/PCM”, it is not possible to switch the audio
These instructions enable you to connect your unit to a Dolby	channel of a bilingual programme recorded on a DVD-RAM or
Digital Decoder or an amplifier with built-in DTS.	DVD-RW (VR mode) disc. In this case, perform the following steps
	using the remote control to switch “DIGITAL AUDIO OUT” from
	“DOLBY DIGITAL/PCM” to “PCM ONLY”.
	A Press SET UP to access the Main Menu screen.
	B Press w e to select “DVD SET UP”, then press t.
	C Press w e to select “AUDIO OUTPUT”, then press t.
	D Press rt to select “DIGITAL AUDIO OUT”, then press
	ENTER.
	E Press rt to select “PCM ONLY”, then press ENTER.
	( pg. 78)
	F Press SET UP to complete the setting.
	G Press AUDIO to select the desired audio channel. ( pg. 50)
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input

Coaxial cable (not provided)

To [DIGITAL AUDIO

OUT (COAXIAL)]

Rear of unit

1 Connect the unit and a Dolby Digital Decoder or an amplifier with built-in DTS using an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 78)

●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”. ( pg. 78)

CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

Page 77

Wednesday, 31 August 2005 19:58