
ELECTRICAL CONNECTIONS
ATypical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1Connect the colored leads of the power cord in the order specified in the illustration below.
2Connect the antenna cord.
3Finally connect the wiring harness to the unit.
Rear line out (see diagram |
| ) | Rear ground terminal |
15 A fuse
Antenna terminal
Ignition switch
Black
To the metallic body or chassis of the car
Yellow*2 | To a live terminal in the fuse block connecting to the car battery |
| (bypassing the ignition switch) (constant 12 V) |
Red | Fuse block |
| To an accessory terminal in the fuse block |
Blue
To the automatic antenna if any (250 mA max.)
Blue with white stripe
To the remote lead of other equipment (200 mA max.)
White with black stripe | White | Gray with black stripe | Gray | Green with black stripe | Green | Purple with black stripe | Purple |
| Left speaker (front) | Right speaker (front) | Left speaker (rear) |
| Right speaker (rear) |
BConnecting the external amplifier or subwoofer
You can connect an amplifier to upgrade your car stereo system.
•Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
•Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Remote lead |
Set “L/O MODE” to “REAR” (See page 15 of the
INSTRUCTIONS.)
Rear speakers |
| JVC Amplifier | ||||||
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Set “L/O MODE” to “SUB.W” (See page 15 of the
INSTRUCTIONS.)
Remote lead
Remote lead (blue with white stripe)
To the remote lead of other equipment or automatic antenna if any
Signal cord*1
Front speakers
Subwoofer
JVC Amplifier
or
*1 Not supplied for this unit.
*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise the power cannot be turned on.
*3 Firmly attach the ground wire to the metallic body or to the chassis of the
2