JVC GET0576-001A manual FADER*7,*8 R06 F06, BALANCE*8, Loud Loud OFF, Muting

ENGLISH

Category		Menu items	Selectable settings, [reference page]
		FADER*7,*8	R06 – F06		: Adjust the front and rear speaker output balance.
		Fader			(Initial: 00)
		BALANCE*8	L06 – R06		: Adjust the left and right speaker output balance.
		Balance			(Initial: 00)
		LOUD	•	LOUD OFF	: Cancels.
		Loudness	•	LOUD ON	: Boost low and high frequencies to produce a well-balanced
					sound at a low volume level.
		VOL ADJUST	VOL ADJ –05		: Preset the volume adjustment level of each source (except
		Volume adjust	—		FM), compared to the FM volume level. The volume level
			VOL ADJ +05		will automatically increase or decrease when you change the
			(Initial: VOL		source.
			ADJ 00)		• Before making an adjustment, select the source you want to
					adjust.
					• “VOL ADJ FIX” appears on the display if “FM” is selected as
					the source.
	AUDIO	L/O MODE	•	SUB.W	: Select if the REAR LINE OUT terminals are used for connecting
		Line output			a subwoofer (through an external amplifier).
		mode	•	REAR	: Select if the REAR LINE OUT terminals are used for connecting
					the speakers (through an external amplifier).
		SUB.W FREQ*9	•	LOW	: Frequencies lower than 72 Hz are sent to the subwoofer.
		Subwoofer	•	MID	: Frequencies lower than 111 Hz are sent to the subwoofer.
		cutoff frequency	•	HIGH	: Frequencies lower than 157 Hz are sent to the subwoofer.
		SUB.W LEVEL*9	SUB.W 00		: Adjust the subwoofer output level.
		Subwoofer level	— SUB.W 08		(Initial: SUB.W 04)
		BEEP	•	BEEP OFF	: Deactivates the key touch tone.
		Key touch tone	•	BEEP ON	: Activates the key touch tone.
		TEL MUTING	•	MUTING 1/	: Select either one which mutes the sounds while using a
		Telephone		MUTING 2	cellular phone.
		muting	•	MUTING OFF	: Cancels.
		AMP GAIN*10	•	LOW POWER	: VOLUME 00 – VOLUME 30 (Select if the maximum power
		Amplifier gain			of each speaker is less than 50 W to prevent damaging the
		control			speaker.)
			•	HIGH POWER	: VOLUME 00 – VOLUME 50
*7	If you are using a two-speaker system, set the fader level to “00.”
*8	This adjustment will not affect the subwoofer output.
*9	Displayed only when “L/O MODE” is set to “SUB.W.”

*10 The volume level automatically changes to “VOLUME 30” if you change to “LOW POWER” with the volume level set higher than “VOLUME 30.”

18