JVC HM-DR10000EK setup guide Load a Cassette, Point, Start Playback, Stop Playback

12BASICOPERATIONS

Playback

Turn on the TV and select the AV mode.

The easiest, most basic operation possible with your video recorder is tape playback. Already-recorded signals on a video tape are read by your video recorder and displayed on your TV just like a TV programme.

●This recorder can play back tapes that have been recorded in D-VHS (MTP), S-VHS and VHS formats.

●When playing back a tape, this recorder automatically identifies the recording format (D-VHS, S-VHS, or VHS).

1

EW	2
	F

4	EJECT	4	STOP	PLAY
				3
		1		3
		2
	3	LAY

FF 2

2 REW

STOP

4

1	LOAD A CASSETTE
	Make sure the window side is up, the rear label side is
	facing you and the arrow on the front of the cassette is
	pointing towards the recorder. Don’t apply too much
	pressure when inserting.
	● The recorder power comes on automatically and the
	counter is reset to 0:00:00.
	● While "– – – –" is blinking on the front display panel,
	the tape will run for a few seconds to search for the
	tape number.
	● If the record safety tab has been removed, playback
	begins automatically.
	FIND PROGRAMME START
2	POINT
	If the tape is advanced past the start point, press REW.
	To go forward, press FF.
3	START PLAYBACK
	Press PLAY. "BEST" appears blinking in the recorder's
	display panel during automatic tracking (only cassettes
	recorded in the S-VHS or VHS mode ☞ pg. 34).
	● Playback picture quality of LP recordings will not be
	as high as SP recordings.
4	STOP PLAYBACK
	Press STOP. Then press EJECT to remove the cassette.

INFORMATION

When using the AV connection (☞ pg. 6), initiating playback causes the VCR indicator to light and the TV to automatically enter AV mode. To return the TV to TV mode after playback is complete, press TV/VCR so that the VCR indicator turns off.

Tape Position Indicator

The tape position indicator appears on screen when, from the Stop mode, you press FF, REW or perform an Index Search. The position of “5” in relation to “0” (beginning) or “+” (end)

shows you where you are on 0 + the tape.

”O.S.D.” (☞ pg. 53) must

be set to “ON”, or the

indicator will not appear. Beginning

3

+ +

1:23:45 REMAIN 2:35

End

*Depending on the type of TV used, TV/VCR button does not always function as described above.

NOTE:

Compact VHS camcorder recordings can be played on this video recorder. Simply place the recorded cassette into a VHS Cassette Adapter and it can be used just like any full- sized VHS cassette.

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.