JVC HM-DR10000EK Remote Control Functions, SET Remote Control, Remote A/B Code Switching

42ADVANCEDOPERATIONS(cont.)

Remote

Control

Functions

Remote control code switch

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

	SET REMOTE CONTROL
1	CODE
	Slide the remote control code switch on the recorder to
	AND"B".
	Press and hold VCR on the remote control for over 2
	seconds, press the NUMBER key "2" and then press OK.

NOTES:

●To set the recorder back to respond to A code signals, repeat the same procedure as shown above, except sliding the remote control code switch to "A" and pressing NUMBER key "1" instead of "2" in step 1.

●If you don't want to control the recorder by the remote control, slide the remote control code switch to "OFF".

VCR

1

2

– –:– –

1	2	3
NUMBER "1"
4	5	6

7 8 9

0

1

3

4

4

3 OK

2