JVC HR-S7300U Turn on the DSS, Receiver, Unplug Vcrs Power, Cord, SET Remote Control, Code, Brand

DIGIT "2"

57

DSS Receiver Multi-Brand Remote Control

The VCR's remote control can control functions on the brands of DSS (Digital Satellite System) receivers listed below.

1 2 3

DIGIT "1"

4 5 6

7 8 9

0

POWER

CH

MBR/VCR

TURN ON THE DSS

RECEIVER

Turn the power on using the DSS receiver's remote

1 control.

SET REMOTE CONTROL

MODE

TV/CABLE

STOP

Control Two JVC VCRs

The remote control is capable of controlling two JVC VCRs independently; one set to respond to your remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR to respond to B code signals.

	UNPLUG VCR'S POWER
1	CORD
	Unplug from the AC outlet.
	SET REMOTE CONTROL
2	CODE
	While holding down STOP on the remote control, press
	the DIGIT key "2".
3	PLUG IN POWER CORD
	Plug back in to the AC outlet.
4	TURN VCR POWER ON
	Press POWER on the remote.

The VCR will now respond only to B-code commands.

To set the VCR back to respond to A code signals, repeat the same procedure as shown above except pressing DIGIT key "1" instead of "2" in step 2.

You can control two VCRs with the same remote control by switching the remote's code between A and B.

		Set the MBR/VCR switch to MBR and set the TV/CABLE
2 switch to CABLE.
		ENTER DSS RECEIVER
		BRAND
		While holding down POWER on the VCR’s remote
		control, use the DIGIT keys to enter the DSS receiver
3 brand number from the chart below and then press
	STOP.
		● Once you have set the remote control to operate the
		DSS receiver, you don't have to repeat this step until
		you replace the remote control's batteries.
4		OPERATE DSS RECEIVER
		First, press POWER to see if the DSS receiver's power
		goes off as it should. If it does, try other functions (CH
		+/– can be used to operate the DSS receiver).
		● To return the remote to VCR control, set the MBR/
		VCR switch to VCR.

NOTE:

Depending on type of DSS receiver, there may be cases where some or all functions cannot be operated using the remote control.

DSS BRAND NAME	BRAND CODE
RCA	80
SONY	81