JVC HR-S7600AM Edit To Or From Another Video Recorder, SET Recording Decks Input Mode

Edit To Or

From Another

Video

Recorder

TV Receiver Player Your recorder

VIDEO	AV Cable
	(not provided)

CHANNEL

RF Cable (provided)

Another recorder

Recorder

EN41

You can use your video recorder as the source player or the recording deck.

1	MAKE CONNECTIONS
	Connect the player's AUDIO/VIDEO OUT connectors
	to the recorder's AUDIO/VIDEO IN connectors.
	● Use the L connector for monaural connection.

SET RECORDING DECK'S

INPUT MODE

2 Set to AUX. With this video recorder, press NUMBER key "0" and/or TV PROG to select depending on the connector being used — "L-1" for the rear panel VIDEO/ AUDIO input connectors, or "F-1" for the front panel VIDEO/AUDIO input connectors.

3	SET EDIT MODE
	See "Picture Control" on page 38.
4	START SOURCE PLAYER
	Engage its Play mode.
5	START RECORDING DECK
	Engage its Record mode.

Recorder Your recorder TV Receiver

AV Cable	VIDEO
	CHANNEL
(not provided)

RF Cable (provided)

Another recorder

Player

IMPORTANT:

●To edit, both the player and the recorder must be of the same colour system. Press your recorder's COLOUR SYSTEM button to select the appropriate colour system.

●For more information on multi-system compatibility, ☞ pg. 50.

NOTES:

●When you use this recorder as the player for editing, be sure to set "O.S.D." to "OFF" before starting (☞ pg. 10).

●All necessary cables can be obtained from your dealer.

●NTSC tapes being played back in the NTSC [PAL mode (☞ pg. 51) cannot be dubbed to another recorder.

●When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or NTSC 4.43) with the COLOUR SYSTEM button (☞ pg. 50).

●When you select EDIT to dub tapes in step 3, be sure to select AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the tapes (☞ pg. 38).

●If you are using another recorder with S-Video and Audio input/output connectors, you can connect those connectors to this recorder's S-VIDEO and AUDIO input/output connectors.

When Using Your Video Recorder As The Source Player ...

... connect its rear panel S VIDEO OUT and AUDIO OUT connectors to the recording deck's S-Video and Audio input connectors.

When Using Your Video Recorder As The Recording Deck ...

... connect its front panel S-VIDEO and AUDIO input connectors to the source player's S-Video and Audio output connectors. Then, set the recorder's input mode to "S-2".

OR

... connect its rear panel S VIDEO IN and AUDIO IN connectors to the source player's S-Video and Audio output connectors. Then, set the recorder's input mode to "S-1".