6 EN
VideoChannel Set

INITIAL SETTINGS

Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
If you have connected the video recorder to your TVvia the provided RF cable only (RF connection) – Go to"With RF Connection" below.If you have connected the video recorder to your TVvia both the provided RF cable and an AV cable (AVconnection), or via the provided RF cable, the providedS-Video cable and an audio cable (S-VIDEO connec-tion) – Go to "With AV Connection or S-VIDEOConnection" on next page.

ACCESS VIDEO CHANNEL

SET MODE
1
Hold down STOP/EJECT on the recorder until the
display panel shows the following.
SELECT TV SYSTEM
2
Press TV PROG + or – to set appropriate TV system that
matches the system of TV being used (refer to the table
below).
TEST SIGNAL
The channel on which the screen to
the left appears clearly in step 3 is
your Video Channel.
To view picture signals from the video recorder, setyour TV to the Video Channel.
IMPORTANT:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
With RF Connection
1 : B/G 2 : D/K 3 : I 5 : M
Major Countries TV System
New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,
Malaysia, Iran, Saudi Arabia, B/G
Egypt, Morocco, Lebanon, Iraq
China, Mongolia, Russia D/K
Hong Kong I
Australia H
U.S.A., Japan, S.Korea, Taiwan M
123
456
789
0
2
4
1
3
REW FF
JOG
SHUTTLE
STANDBY/ ON
TIMERS-VHS ET STOP/EJECT DIGITAL
TBC/NR
PAUSE
PLAY
VIDEOS-VIDEO (S-2)
(MONO)
L —AUDIO— R
TV PROG
SYNCHRO EDIT
SP/LP/EP
COLOUR SYSTEM
INSERT A.DUB
REC
TV PROG+/–
OK
4 : H
STOP/EJECT
TV PROG