14 EN

INSTALLING YOUR NEW UNIT

Basic Connections

Antenna or Cable

Coaxial cable

Flat feeder

Matching transformer

(not supplied)

AC Outlet

AUDIO/VIDEO OUTPUT

AC Power Cord

1

Back of unit

VHF/UHF IN

 

VHF/UHF OUT

Audio/video cable (not supplied)

RF cable (supplied)

To Audio/video input connectors

TV

To 75 ohm Terminal

It’s essential that your unit be properly connected.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

A Check the contents.

Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 88.

B Situate the unit.

Place the unit on a stable, horizontal surface.

C Connect the unit to TV.

The connection method you use depends on the type of TV you have.

RF Connection8To connect to a TV with NO AV input connectors —

ADisconnect the TV antenna from the TV.

BConnect the TV antenna cable to the VHF/UHF IN connector on the rear panel of the unit.

CConnect the supplied RF cable between the VHF/UHF OUT connector on the rear panel of the unit and the TV’s antenna terminal.

AV Connection8To connect to a TV with AV input connectors —

AConnect the antenna, unit and TV as per “RF Connection”.

BConnect an optional audio/video cable between the AUDIO/VIDEO OUTPUT connectors on the rear panel of the unit and the TV’s audio/video input

connectors.

●Set your TV to AV mode.

●For switching the TV’s mode, refer to the instruction manual of your television.

●To obtain high-quality pictures, you can also use the S-VIDEO

connection or Component Video Connection. (DVD deck only) ( pg. 15, 16)

D Connect the unit to power source.

Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 17)

●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)

E Set the VCR channel.

The VCR channel is the channel on which you can watch the picture from the unit on the TV when only using RF connection.

With RF connection, set the VCR channel to “3 CH” or “4 CH”.

●The VCR channel is preset to “3 CH”. Set to “4 CH” if the Channel 3 is used for broadcasting in your area.

With AV connection, set the VCR channel to “– CH” (off). To set the VCR channel, perform the following steps:

Before performing the following steps:

●Make sure there is no cassette inserted in the unit.

●Make sure the unit is turned on, then press VCR/ DVD on the unit or VCR on the Remote so that the VCR indicator lights up.

APress POWER (1) to turn off the unit, then press STOP (8) on the unit for more than 5 seconds. “3 CH”

appears on the front display panel.

BPress CH +/– on the Remote to select “3 CH”, “4 CH” or “– CH” (off), then press ENTER.