JVC HR-XVC37U 16 EN, Component Video Connection, INSTALLING YOUR NEW UNIT (cont.), VCR, ENTER, CH +/–, VCR/ DVD, Before performing the following steps:

16 EN

INSTALLING YOUR NEW UNIT (cont.)

Component Video Connection

ATTENTION

Be sure to connect the unit’s VIDEO OUTPUT (DVD/ VCR) connector to the TV’s VIDEO input connector.

Antenna or Cable

Coaxial cable

Flat feeder
	Matching transformer
AC outlet	(not supplied)
AC outlet
	VHF/UHF IN
AC power cord	VHF/UHF OUT
	VHF/UHF OUT
	AUDIO/VIDEO OUTPUT

Back of unit

COMPONENT
VIDEO OUT
Audio/Video cable
(not supplied)
Component	RF cable
Video cable	RF cable
(not supplied)	(supplied)
TV
To Component Video	To 75 ohm
Input connector	Terminal

8To connect to a TV with component video input connectors . . .

A Connect the unit to TV.

AConnect the aerial, unit and TV as per “AV Connection”. ( pg. 14)

BConnect the unit’s COMPONENT VIDEO OUT connectors to the TV’s component video input connectors.

B Connect the unit to power source.

Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 17)

●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)

C Set the VCR channel to off.

Before performing the following steps:

●Make sure there is no cassette inserted in the unit.

●Make sure the unit is turned on, then press VCR/ DVD on the unit or VCR on the Remote so that the VCR indicator lights up.

APress POWER (1) to turn off the unit, then press STOP (8) on the unit for more than 5 seconds. “3 CH”

appears on the front display panel.

BPress CH +/– on the Remote to select “– CH” (off), then press ENTER.

NOTES:

●You can obtain high-quality component video pictures.

●If your TV is not stereo-capable, use the unit’s AUDIO OUTPUT connectors to connect to an audio amplifier for Hi-Fi stereo sound reproduction.

●To operate the unit with your TV using the Component Video connection, set your TV to its AV mode. You can also use the TV/VCR button on the unit’s Remote to set JVC TV to the AV mode.

●For switching the TV’s mode, refer to the instruction manual of your television.

●By using the component video connection, you can view the images in the progressive mode. For switching to the

progressive mode, refer to “Progressive Scan Mode Set (VCR deck/DVD deck)” ( pg. 28).