•OFF: Select when you want to enjoy playback with its full dynamic range (no effect applied).
•MID: Select when you want to reduce the dynamic range a little.
•MAX: Select when you want to apply the compress effect fully (useful at a low volume level).
SPEAKER SIZE
Set speaker information correctly.
•FRONT/CENTER/REAR:
Set the speaker size properly.
–LARGE: If the cone speaker size is more than 13 cm
–SMALL: If the cone speaker size is less than 13 cm
–NONE: If not used.
•SUBWOOFER:
Select “YES” (connected) or “NO” (disconnected).
•SUBWOOFER PHASE:
Select either “NORMAL” or “REV. (reverse)” to obtain better subwoofer sounds.
•These settings are very related to one another; therefore, one setting is changed, some other settings will be changed automatically and appropriately (see page 80).
•Sound comes out of the subwoofer for Dolby Pro Logic II only when either the front speakers or the center speaker is set to “SMALL.”
CROSS OVER
You can select the crossover frequency for the small speakers used. The signals below the preset frequency level will be sent to the subwoofer (or to the “LARGE” speakers when “SUBWOOFER” is set to “NO”).
AMP GAIN
You can change the maximum volume level of this unit. When the maximum power of the speakers is less than 50 W, select “LOW”
to prevent them from being damaged.
•HIGH: You can adjust the volume level from “0” to “50.”
•LOW: You can adjust the volume level from “0” to “30.”
ENGLISH
51
