JVC KY-F550E instruction manual Preparation Before Shooting, Connecting Through Analogue Output

2. Preparation Before Shooting (continued)

Connecting Through Analogue Output

Images taken by this unit can be output to monitor, colour video printer or other devices.

	BNC CABLE
	[VIDEO OUT]
Monitor	Clamp filter	POWER DC IN
	DV
	(accessories)

‘Connecting the

Power Supply’	AA-P700
(Page 18)	AC ADAPTER AA-P700
	POWER
	ON	AC IN
	OFF
[DC IN]
	AC Adapter
REMORT MANUAL

[RGB, Y/C, SYNC OUT]

VC-451-2

MITSUBISHI	R
	G/Y
	B/C
	SYNC
Colour Video Printer etc.	VBS

RGB, Y/C, SYNC OUT

VIDEO OUT
LENS	TRGGER

SEE INSTRUCTION	[REMOTE]
	[TRIGGER]

MENU

	REMOTE
Microscope	CONTROL
Adapter	UNIT
	RM-LP55
	RM-LP57
	Trigger Switch

1. Connect device such as the Colour Video Printer to this unit’s [RGB, Y/C, SYNC OUT] terminal.

2. Set the switches located at the side of this unit.

●Setting Switch 2

Set this switch to [ON] (upper side) for Y/C output.

Set this switch to [OFF] (lower side) for RGB output.

●Setting Switch 3

Set this switch to [ON] (upper side) if sync sig- nal is to be superimposed onto the Green (G)

channel of the video signal.

☞Page 10 ‘9 Function Setting Switch’ Example: During RGB output

1 2 3 4 ON

OFF

Switch 2 Switch 3

3. Switch on the power of this unit.

Caution

●Perform this when the devices are off.

●Use the 1/3-inch, C mount adapter for the micro- scope adapter.

Notes

●Connect a switch between PIN 2 (TRIG) and PIN 3 (GND) of the [TRIGGER] terminal. If this switch is set to [ON], a trigger will freeze the input image to the camera and capturing of images synchro- nized with the trigger is possible.

●Ensure to attach the supplied clamp filter to the cable connected to the Analog Signal Output [RGB, Y/C, SYNC OUT] terminal in order to re- duce unwanted electromagnetic emissions.

☞ Page 48

E-16