JVC KY-F550E instruction manual
White Spots Correction Messages, Ccd

White Spot Correction (continued)

White Spots Correction Messages

Detecting Screen

PIXEL COMPEN

EXECUT I NG

Detection Completed Screen

PIXEL COMPEN

OK

TURN POWER OFF

AND ON AGAIN.

English

Detection Error Screen

PIXEL COMPEN

ERROR : LENS NOT CLOSED?

PIXEL COMPEN

ERROR : COUNT OVER

TURN POWER OFF AND ON AGAIN.

Notes

●The white spot correction feature of this unit does not correct all white spots. Detection and correction of white spots by this unit is performed under the following conditions. White spot correction will not be performed under conditions beyond those stated. In cases where conditions are fulfilled, correction may not be successfully performed depending on the nature of the white spots.

In such case, perform the detection again until white spots are detected. Consult your JVC authorized dealer if white spots cannot be corrected. Quantity of Detection/Correction: 32 or less

● The screen on the right may be displayed during detection of white spots	PIXEL	COMPEN
	ERROR : LENS	NOT CLOSED?
in cases when light enters the CCD during detection or depending on the
condition of white spots. In this case, check if there is light entering the
CCD.
● During white spot correction, pixel data is obtained via interpolation of
pixel information from the surroundings. Thus data may not be accurate
for fine images.
● Results of white spot detection will be stored until the next detection is	PIXEL	COMPEN
performed.
	ERROR : COUNT OVER
● During white spot detection, operation via the remote control will be disa-	TURN POWER OFF
bled.	AND ON AGAIN.

E-29