JVC LPT0970-001A, 0504CSH-ID-VT manual 58 EN

58 EN REMOTE CONTROL

Remote Control Functions

Remote A/B/C/D Code Switching

The remote control is capable of controlling four JVC video units independently. Each of the units can respond to one of four codes (A, B, C or D). The remote control is preset to send A code signals because your unit is initially set to respond to A code signals. You can easily modify your unit to respond to B, C or D code signals.

Before performing the following steps:

Slide the TV/VCR/DVD switch to the right.

On the remote control

Keep pressing VCR down during steps A – B.

A Change the remote control code.

Press the number key “1” for A, “2” for B, “3” for C or “4” for D.

B Set the remote control code.

Press OK to set the code.

On the unit

C Turn off the unit.

Press 1.

D Display the code.

Press 4 on the unit for over 5 seconds while the unit is turned off. The code currently set appears on the front display panel.

●If the code displayed on the front display panel is different from the code set on the remote control, go to step E.

E Change the unit’s code.

Press 8 on the remote control. The code currently set on the remote control will be applied to the unit.

NOTE:

When “POWER SAVE” is set to “ON” ( pg. 64), it is impossible to change the remote code.